Ipv6 Firewall - D-Link DIR-820L User Manual

The DIR-820L's IPv6 Firewall feature allows you to configure which kind of IPv6 traffic is allowed to pass through the device.
This feature functions in a similar way to the IP Filters feature.
Enable IPv6 Ingress TBD
Filtering:
Check the box to enable the IPv6 firewall simple security.
Enable IPv6 Simple
Security:
Select one of the following options:
Configure IPv6 firewall
Turn IPv6 firewall off
below:
Turn IPv6 Firewall ON and ALLOW Rules listed
Turn IPv6 Firewall ON and DENY Rules listed
Enter a name to identify the IPv6 firewall rule.
Name:
The schedule for when the IPv6 Firewall Rules will be enabled may be
Schedule:
set to Always or Never. Or you can create your own schedule in the
Tools > Schedules section.
Use the Interface drop-down menu to specify the interface that
Source:
connects to the source IPv6 addresses of the firewall rule.
Use the Interface drop-down menu to specify the interface that
Dest:
connects to the destination IP address of the firewall rule.
Enter the Source IPv6 address range in the adjacent IP Address Range
IP Address Range:
field, and enter the Dest IPv6 address range in the other IP Address
Range field below.
Select the protocol of the firewall port (Any, TCP, UDP, or ICMP).
Protocol:
Enter the first port of the range that will be used for the firewall rule
Port Range:
in the first box and enter the last port in the range in the second box.
D-Link DIR-820L User Manual

IPv6 Firewall

88