Installing The Trim Ring - Audiovox VODDLX10 Installation Manual

10.1" overhead led backlit lcd monitor with dvd player
Hide thumbs Also See for VODDLX10:
Table of Contents

Advertisement

INSTALLING THE TRIM RING

The trim ring is attached to the video monitor using the perimeter screw bosses. It is important that the screws used in this installation are not over
tightened, and that the video monitor and trim ring are mounted in such a way that the assembly does not distort (or bend) when the mounting
screws are tightened.
There are two Trim Ring options for mounting the VODDLX10, one is to use the supplied Trim Ring for all vehicles with flat headliner mounting
areas (no contour) or a thick Trim Ring (not supplied) that can be cut to fit the contour of a headliner that is not flat (see Appendix B of this manual)
NOTE: The trim rings supplied with this unit are not designed to be trimmed.
Installing the Trim Ring
1.
Turn the DVD Player over on a surface with protective covering to prevent scratches.
2.
Using a screwdriver, remove the three screws located in the "A" locations shown in the figure above. These screws can be discarded as new
screws are supplied in the hardware kit.
3.
Place the trim ring onto the DVD Player.
®
ELECTRONICS CORP .
150 Marcus Blvd., Hauppauge, NY 11788
Technical Assistance: 1-800-225-6074
MODEL NO. : VODDLX10
Power + Dome Light 6-Pin Harness
Connector
Signal Name
Color
CON6
LAMP-AUTO
VIO/BRN
(BLACK)
LAMP-ON
RED/BLK
LAMP-COMMON
BLK/RED
POWER +12v (SW)
RED
POWER GROUND
BLACK
AV Input 5-Pin Harness
Connector
Signal Name
Color
CON5
VIDEO-IN
YELLOW
(BLUE)
AUDIO L-IN
WHITE
AUDIO R-IN
RED
AV Output 5-Pin Harness
Connector
Signal Name
Color
CON2
VIDEO-OUT
YELLOW
(WHITE)
AUDIO L-OUT
WHITE
AUDIO R-OUT
RED
Made in China
This device complies with FCC Rules Part 15.
Operation is subject to the following two
conditions : (1) This device may not cause
harmful interference and (2) This device must
accept any interference that may be received,
including interference that may cause
(A)
undesired operation.
This product is Class 1 Laser Product and
complies with FDA Rules 21 CFR Chapter 1,
Subchapter J.
Licensed under one or more of the following patents,
Patent NOS. 5,775,762 , 5,927,784 and 6,678,892
FCC ID : ATI9R3ODM21012
7
(A)
Inspected By :
132-7828
(A)

Advertisement

Table of Contents
loading

Table of Contents