Installing The Trim Ring - Audiovox AVXMTG13UA Installation Manual

INSTALLING THE TRIM RING

NOTE: The trim rings supplied with this unit are not designed to be trimmed.
The trim ring is attached to the video monitor using the perimeter screw bosses� It is important that the screws used in this installation are not over
tightened, and that the video monitor and trim ring are mounted in such a way that the assembly does not distort (or bend) when the mounting
screws are tightened�
NOTE: Some applications will not require a trim ring to be installed.
1� Turn the DVD Player over on a surface with protective covering to prevent scratches�
2� Place the trim ring onto the DVD Player so that the two pins on the trim ring ("A") line up with the two alignment holes on the top surface of
the monitor ("B") shown in the figure below �
Trim Ring
(A)
(A)
3� Locate the ten (10) M2�6 x 6mm Self-Tapping Screws (P/N 100-2568) in the hardware kit�
4� Using a screwdriver, install the ten (10) M2�6 x 6mm Self-Tapping Screws (P/N 100-2568) into the locations marked "C" shown in the figure above�
NOTE: Use caution tightening screws as the threads may strip in the DVD Player.
(B)
DVD
PLAYER
(B)
8
(C)
(C) (C)
TRIM RING ON
(C)
(C)
(C) (C)
(C)
DVD PLAYER
(C)
(C)