Installing The Snap-On Shroud And Screen Cover - Audiovox VODDLX10 Installation Manual

INSTALLING THE SNAP-ON SHROUD AND SCREEN COVER

Installing the Shroud
*NOTE: Work on a soft surface to avoid damaging the plastic.
1. Remove the tape backing from the front and rear areas at the
bottom of the shroud.
2. Hook the shroud over the dome light (areas "A" as shown).
3. Carefully align the two catches (1) with the openings on the DVD
player (2) and slide the Shroud down until the Shroud snaps into
the catches on either side.
4. Apply pressure to the front and rear of the shroud in the area of
the double sided tape to ensure that the tape adheres.
Installing the Screen Cover
1. Open the LCD screen.
2. Hook the two tabs "B" (as shown) on the bottom edge of the
screen.
3. Carefully snap the opposite side over the hinge.
NOTE: If the wrong color Shroud and Screen Cover is installed, refer to
Appendix A of this manual for instructions to change the Shroud and
Screen Cover color.
Tape Backing
1
(Front and Rear)
2
(A)
(B)
6
1
2
(A)
(B)