Chapter 6. Maintenance Service And Trouble Shooting - Haier HLP24E Service Manual

Service Manual
Order No. TL1001S003V0
Chapter. 6 MAINTENANCE SERVICE AND TROUBLE SHOOTING
Phenomena
The digitron displays E0.
The drainage cannot
work, or is too slow. The
digitron displays E1.
It stops running in
midway. The digitron
displays E2.
The safety switch acts,
and the spinning cannot
work. The digitron
displays E3.
not work, or is slow, the
digitron displays E4.
The digitron displays E6.
The Not wash
machine
does not
act
Not spin
There is abnormal sound
inside the machine
The water tap leaks
Phenomena
The spinning is intermittent when it starts.
Push the spin" button to select Spin", but it doesn t
work.
There may be some water flowing out of the drain hose
in the first use of the machine.
The wash procedure is paused .
The pulsator pauses during water inlet in wash
and rinse.
When the power plug is inserted,computer board
indicator is switched on, and the machine starts
working.
The reason
The top lid is open during
reserve procedure.
Is the drain hose put down ?
Is the drain hose blocked?
The top lid is not closed.
When using the child lock function,
if the top cover is opened, the
machine will stop and display E2
alarm. After 15 minutes the machine
will automatic drainage
Are the laundries put slantingly?
Is the machine slanting?
Is the water tap opened, or is
there water supply failure?
Is the water inlet valve blocked?
Is the water pressure too low?
The water level sensor is bad.
Is there power failure?
Is the power plug inserted tightly?
Is the water level reached preset
position?
Is the power plug inserted tightly?
Is the top lid closed reliably?
Is the machine slanting?
Are the laundries put slantingly in
spinning?
Are there any foreign materials?
Is the screw of the jointer of water
inlet hose loose or awry?
How to settle
Close the top lid.
Put down the drain hose . Open and
close the top lid once.
Clean the foreign material. Open and
close the top lid once.
Close the top lid.
clear the E2 alarm, please close the top
cover and press the START/PAUSE "
button. Then E2 alarm will be cleared.
Reorder the laundries. Close the top lid.
Place the machine horizontally, open
and close the top lid once.
Open the water tap. Open and close the
top lid once.
Clean the water inlet valve then open
and close the top lid once.
Use after the water pressure is normal.
Please contact the after-sales service
department.
Please use it when there s power
supply.
Insert the power plug tightly.
Fill water to the preset position.
Insert the power plug tightly.
Close the top lid.
Adjust the machine to be even
Reorder t he laundries and close the top
lid.
Remove the foreign materials.
Fasten the screw of the jointer properly.
Explanation
Balance the laundries to avoid slanting.
The program is setting the drain time. Some time is
needed before it starts spinning.
It is the water remained in the factory inspection of
performance.
The cloth sensor is checking the cloth, it will add
water after 48 seconds.
It is to avoid splashing during water inlet.
It is the special resume function. In the case of power
failure or the power plug is loose during washing, the
machine can save the running program, and resume
the program after the power supply is recovered. You
do not need to set the program again.
15
Issue
Rev.