Event Timer - Silvercrest SFB 10.1 A1 Operating Manual

5. Position the remote control in such a way that your infra-
red signal can reach the device to be switched off. After
expiration of the set time the remote control will switch the
device off.
6. If you now press the S button r "SL" is shown in the dis-
play q below on the left.

Event timer

The remote control has 4 event timers available via which
you are allowed to send out specific series of button combi-
nations at designated times.
1. Hold down the S button r for a little longer than 3 sec-
onds. The notice "CODE SETUP" appears.
2. With the  or  button t select "TIMER SETUP" and
confirm with the OK button l. "TIMER SLEEP" appears
in the LCD display q. With the  or  button t select
the desired memory slot "TIMER SETUP 1" to "TIMER
SETUP 4" and confirm with the OK button l.
3. Now the hour of the time of day, to which the desired
button combinations are to be carried out, blinks. Set with
the  or  button t the desired hour and press for con-
firmation the OK button l.
4. Now the minutes of the time of day, to which the desired
button combinations are to be carried out, blinks. Set with
the  or  button t the desired minutes and press for
confirmation the OK button l.
5. In the LCD display q you will see "TIMER X KEY" (X
stands for the desired timer). Now press the desired
device button e followed by the desired sequence of the
button commands.
6. By default, the timer commands are sent at intervals of 1
second. Since many devices react sluggishly, it is possible
that the sequences of the timer commands are sent to the
device too quickly. Then you have the option of program-
ming, before a button command, a pause of between 5
to 21 seconds. For this press, if necessary repeatedly, on
the MACRO button i. Below and to the right the LCD
display q shows the current pause length in seconds.
7. Press the S button r to save your entry and to return to
the timer menu.
8. Procede in a similar manner in order to, if required,
programme the other timer memory slots also.
9. With programmed event timer the LCD display q shows
the timer symbol „ " on the right next to the time.
Tips:
1. Per timer memory slot a maximum of 14 buttons can be
programmed. After entry of the 14th button the sequence
will be automatically saved and "FULL" is shown in the
LCD display q.
2. In this menu also the device will return to the standard dis-
play after approx. 15 seconds without an entry.
- 18 -