Main Fuse; Fuses; Removing And Mounting The Headlight Mask; Replacing The Headlight Bulb - KTM LC4 ADVENTURE R 640 2000 Owner's Handbook Manual

1
26
5
3
2
4
5
7
6

Main fuse

Located near the battery under the seat, the main fuse
consumers.
Replace a blown fuse only with an equivalent one. If a new fuse that has
just been set in gets blown again, you are strongly advised to have it ins-
pected by a KTM dealer.
The fuse capacity is 10 Ampere.
!
U
NDER NO CIRCUMSTANCES IS A STRONGER FUSE ALLOWED TO BE SET IN OR A FUSE
" ". A
ALLOWED TO BE REPAIRED N INEXPERT TREATMENT COULD DAMAGE THE WHOLE
!
ELECTRICAL INSTALLATION
Fuses for individual power-consuming units
Additional fuses separately protecting different power-consuming units are
mounted under the cockpit cover.
The fuses can be pulled out underneath the cockpit cover for replacement.
Fuse 2 (10 Ampere) protects the following power-consuming units:
– headlight
– parking light
– tripmaster
3
Fuse (10 Ampere) protects the following power-consuming units:
– flasher lights
– brake light - foot brake lever
– horn
– radiator fan
Fuse 4 (10 Ampere) protects the following power-consuming units:
– ignition
– starter system
– brake light - hand brake lever
Replace a blown fuse only with an equivalent one. If a new fuse that has
just been set in gets blown again, you are strongly advised to have it
inspected by a KTM dealer.
!
U
NDER NO CIRCUMSTANCES IS A STRONGER FUSE ALLOWED TO BE SET IN OR A FUSE
" ". A
ALLOWED TO BE REPAIRED N INEXPERT TREATMENT COULD DAMAGE THE WHOLE
!
ELECTRICAL INSTALLATION

Removing and mounting the headlight mask *

The headlight mask must be removed to replace the headlight lamps, the
indicator lamps or the tachometer lamps.
REMOVING THE HEADLIGHT MASK
– Use the wrench from the tool kit to remove the 6 screws
light mask.
– Swing the headlight mask forward, disconnect the flasher cables and
remove the mask.
MOUNTING THE HEADLIGHT MASK
– Hold the headlight mask and connect the flasher cables.
– Position the headlight mask and replace the screws without tightening
them yet.
– Tighten all 6 screws at once with 5 Nm (4 ft.Ibs).

Replacing the headlight bulb *

The headlights are accessible after you have removed the headlight mask.
6
– Turn the cover counterclockwise, and remove it.
7
– Detach the spring bar , and remove the lamp from the headlight
– insert and connect a new H1 lamp (12 V 55 W)
!
T
HE GLASS OF THE BULB MUST BE FREE OF OIL AND GREASE
. T
OIL TO VAPORIZE HE RESULTING VAPOR ON THE REFLECTOR DECREASES THE
BRIGHTNESS OF THE HEADLIGHT
– Start the engine and check the headlight for proper functioning.
– Place the cover in position, and turn it clockwise.
1
protects all power
CAUTION
CAUTION
CAUTION
. T
HE HEAT CAUSES THE
.
!
!
5
of the head-
!