Smoothtop Surface - Maytag Precision Touch Control 800 Use & Care Manual

Smoothtop Surface

Notes:
• Cooktop may emit light smoke and odor the first few
times the cooktop is used. This is normal.
• Smoothtop cooktops retain heat for a period of time
after the element is turned off. Turn the elements off
a few minutes before food is completely cooked and use
the retained heat to complete cooking. When the hot
surface light turns off, the cooking area will be cool
enough to touch. Because of the way they retain heat, the
smoothtop elements will not respond to changes in
settings as quickly as coil elements.
• In the event of a potential boilover, remove the pan from
the cooking surface.
• Never attempt to lift the cooktop.
• The smoothtop surface may appear discolored when it is
hot. This is normal and will disappear when the surface
cools.
Cooking Areas
The cooking areas on your range are identified by permanent
circles on the smoothtop surface. For most efficient cooking,
fit the pan size to the element size.
Pans should not extend more than
the cooking area.
When a control is turned on, a glow can be seen through the
smoothtop surface. The element will cycle on and off to
maintain the preset heat setting, even on High.
For more information on cookware, refer to Cookware
Recommendations on page 11.
FLEX-CHOICE TM
ELEMENT
9" ELEMENT
Hot Surface Light
The Hot Surface indicator light is located on the control panel.
The light will be illuminated when any cooking area is hot. It
will remain on, even after the control is turned off, until the
area has cooled.
Warming Center
Use the Warming Center to keep hot cooked
foods warm, such as vegetables, gravies
and oven-safe dinner plates.
Setting the Control:
1. Push in and turn the knob. Warming
temperatures are approximate and
are indicated on the control as Min, 2-
8 and Max. However, the control can be
set to any position between Min and Max.
1 / to 1-inch beyond
2
WARMING CENTER
6" ELEMENT
12" ELEMENT
10
2. When done, turn the control to OFF and remove food. The
Hot Surface indicator light will go off when the Warming
Center surface has cooled.
Notes:
• Never warm food for longer than one hour (eggs for 30
minutes), as food quality may deteriorate.
• Do not heat cold food on the Warming Center.
• Heat settings will vary depending on type and amount
of food. Always hold food at proper food temperatures.
USDA recommends food temperatures between
140°-170° F.
Suggested Settings
Setting
Min - 2 Breads/Pastries
Casseroles
2 - 5 Dinner Plate with Food
Soups (Cream)
Vegetables
5 - Max Fried Foods
Soups (Liquid)
Notes:
• Use only cookware and dishes recommended as safe for
oven and cooktop use.
• Always use oven mitts when removing food from the
Warming Center as cookware and plates will be hot.
• All foods should be covered with a lid or aluminum foil to
maintain food quality.
• When warming pastries and breads the cover should have
an opening to allow moisture to escape.
• Do not use plastic wrap to cover foods. Plastic may melt
on to the surface and be very difficult to clean.
TM
Flex-Choice Element
(select models)
The Flex-Choice TM element is fully a
functioning element that provides an
ultra low Melt heat setting for melting
chocolate and butter. It is located in the
left rear position.
The Melt setting is located between 2 and OFF.
Heat settings outside of this area function as a normal
element, with 2 (Low) to High settings.
Note: When using the normal settings for preparing foods,
it may take a few minutes for the cooking area to cool to
the Warm heat setting.
Type of food
Gravies
Eggs
Sauces
Stews
Meats
Hot Beverages