Removing The Drain Pan; Removing The Filter-Drier; Removing The Evaporator - Electrolux FROST- FREE Service Manual

Removing the Evaporator Cover:
1. Disconnect power from the freezer, remove the
cold control and fan housing cover and release the
top of the evaporator cover.
2. Remove the cold control, disconnect the fan
mounting bracket and release any wire clips from
the cover.
3. Remove the two plastic straps, one on each end,
holding the evaporator to the cover and lift the cover
off.

Removing the Drain Pan:

1. Disconnect power from the freezer and remove the
machine compartment cover.
2. The drain pan is mounted to the top of the
compressor and is held in place by a plastic tab
through a slot in the compressor housing.
3. To remove the drain pan, pull out.

Removing the Filter-Drier:

1. Disconnect power from the freezer and remove the
machine compartment cover.
CAUTION: On R-134a systems, the system must
NOT be left open to the atmosphere for
more than 10 minutes to prevent
moisture contamination of compressor
oil.
2. Recover refrigerant by using EPA approved
recovery system.
CAUTION: DO NOT un-braze old filter-drier from
system. This will vaporize and drive
moisture from desiccant back into
system. The old filter-drier should be
cut out of system.
3. Using a three corner file score and break the tube
at the bottom of the filter-drier.
4. Remove the filter-drier by cutting the tube at the top
of the filter-drier as close as possible.
40