Table of Contents
Advertisement
C C o o m m p p o o n n e e n n t t T T e e a a r r d d o o w w n n
D D r r a a i i n n P P a a n n R R e e m m o o v v a a l l
The drain pan is secured with four screws to the
bottom of the unit frame.
To remove the drain pan:
1. Pull unit from its installation position. The front
of the unit will need to be raised to access the
drain pan screws.
CAUTION
U U s s e e c c a a u u t t i i o o n n w w h h e e n n t t i i l l t t i i n n g g a a f f r r e e e e z z e e r r u u n n i i t t . . U U s s e e
s s t t u u r r d d y y b b l l o o c c k k i i n n g g m m a a t t e e r r i i a a l l s s t t h h a a t t w w i i l l l l n n o o t t a a l l l l o o w w t t h h e e
f f r r e e e e z z e e r r t t o o r r o o c c k k o o r r t t i i p p o o v v e e r r w w h h e e n n s s e e r r v v i i c c i i n n g g t t h h e e
u u n n i i t t . .
2. Using a short phillips head screwdriver, extract
the four screws securing the drain pan to the
bottom of the unit frame. (See Figure 5-29)
3. Allow the drain pan to drop down. Pull drain
tube from drain pan.
4. Pull condenser tubes out of the retainers
mounted to the drain pan.
C C o o n n d d e e n n s s e e r r F F a a n n M M o o t t o o r r R R e e m m o o v v a a l l
The condenser fan motor is secured with three
screws to the condenser fan motor bracket. Two
hooks and two screws at the base of the
condenser fan motor bracket secure the assembly
to the unit base. (See Figure 5-30)
To remove the condenser fan motor:
1. Pull unit from its installation position. The front
of the unit will need to be raised to access the
drain pan screws.
2. Extract the screws securing the compressor
shield to the unit frame and remove from unit.
3. Disconnect wire harness from the wire leads of
condenser fan at quick disconnect.
4. Remove the four drain pan screws. Allow the
drain pan to drop from its installation position.
5. With a needle nose pliers, reach behind air
divider and compress the plastic retainers
while pushing them out of the condenser fan
mounting bracket. Remove air divider.
6. Using a 1/4" socket or wrench, extract the two
screws securing the fan mounting bracket to
the unit frame.
7. Using a phillips head screwdriver, extract the
three screws securing the fan motor to the fan
mounting bracket.
8. Pull fan motor and fan blade out from behind
the mounting bracket. Remove fan blade by
pulling the fan blade from the motor shaft.
Condenser
Retainers
Screw
Figure 5-29. Drain Pan Removal
Electrical Connection
Fan Blade
Fan Motor
Figure 5-30. Condenser Fan Components
5-14
Drain Pan
Bracket
Screws
Fan
Plastic
Motor
Retainers
Screws
Air Divider
Advertisement
Table of Contents
