Troubleshooting - Hunter Seville Installation And Operation Manual

cleaning your ceiling fan
caring for finishes
For cleaning, a soft brush or lint-free cloth should be used to prevent
scratching the finish. A vacuum cleaner brush nozzle can remove
heavier dust. Surface smudges or an accumulation of dirt and
dust can easily be removed by using a mild detergent and a slightly
dampened cloth. An artistic agent may be used, but never use
abrasive cleaning agents as they will damage the finish.
caring for blades
Wood finish blades should be cleaned with a furniture polishing
cloth. Occasionally, a light coat of furniture polish may be applied
for added protection and beauty. Painted and high-gloss blades
© 2007 Hunter Fan Company
may be cleaned in the same manner as the fan finish.

troubleshooting

Problem: Nothing happens; fan does not move.
1. Turn power on, replace fuse, or reset breaker.
2. Loosen canopy, check all connections according to the
wiring the fan section.
3. Check the plug connection in the switch housing.
4. Push motor reversing switch firmly up or down to ensure
that the switch is engaged.
5. Pull the pull chain to ensure it is on.
6. Remove the shipping bumpers.
Problem: Noisy operation.
1. Tighten the blade bracket screws until snug.
2. Tighten the blade screws until snug.
3. Check to see if the blade is cracked. If so, replace all the
blades.
4. Change to an approved speed control.
5. Be sure that the glass is secure.
6. Check and tighten the screws in the switch housing
mounting plate and in the upper and lower switch hous-
ing.
Problem: Excessive wobbling.
1. If your fan wobbles when operating, use the enclosed
balancing kit and instructions to balance the fan.
2. Tighten all blade and/or blade iron screws.
3. Turn power off, support fan very carefully, and check that
the hanger ball is properly seated.
If you need parts or service assistance, please call 888-830-1326 or
visit us at our WEB site at http://www.hunterfan.com.
Hunter Fan Company
2500 Frisco Avenue

41865-01 01/15/2007