Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Hunter Seville
Summary of Contents for Hunter Seville
- Page 1 © 2007 Hunter Fan Company 41865-01 01/15/2007 41865-01 01/15/2007...
-
Page 2: Cautions And Warnings
If you need help installing the fan, your Hunter fan dealer can direct you to a licensed installer or electrician. gathering the tools ® Your new Hunter ceiling fan is an addition to your home or office You will need the following tools for installing the fan: that will provide comfort and performance for many years. -
Page 3: Preparing The Fan Site
Figure 5 - Adequate existing fan site 7’ Minimum If your existing fan site is suitable, go to the installing the ceiling to Floor plate section and begin installing your new Hunter fan. preparing a new fan site To prepare the fan site follow four steps: Figure 4 - Minimum mounting distances •... -
Page 4: Installing The Ceiling Plate
Figure 7. the raised areas on each isolator into the holes in the ceiling plate. Refer to Figure 9. Support Brace Isolators Washer Outlet Box Ceiling Plate 1/16” Recess Wood Screw Figure 9 - Inserting the isolators into the ceiling plate Figure 7 - Installing the outlet box 41865-01 01/15/2007 © 2007 Hunter Fan Company... -
Page 5: Assembling The Fan
NOTE: The rubber washers should be tight enough to keep threads. Do not remove this coating; the coating prevents the hook standing straight up, but the set screw should not the downrod from unscrewing. Once assembled, do not be completely tighten as to keep the hook from being able to remove the downrod. swing. Continue to the hanging the fan section. © 2007 Hunter Fan Company 41865-01 01/15/2007... -
Page 6: Hanging The Fan
(one wall switch required), or Figure 8 - Rotating the fan • control the light with one wall switch and the fan with another (two wall switches required). 41865-01 01/15/2007 © 2007 Hunter Fan Company... -
Page 7: Assembling The Blades
Hook the tab hole over the tab on the ceiling plate as shown Hunter fans use several styles of fan blade irons (brackets that hold in Figure 19. the blade to the fan). -
Page 8: Installing The Light Fixture
Feed the upper plug connector through the center opening of the upper switch housing. See Figure 26. Upper Switch Housing Lower Plug Upper Plug Connector Connector Housing Lower Assembly Switch Screw Housing Figure 8 - Connecting the plug connectors 41865-01 01/15/2007 © 2007 Hunter Fan Company... - Page 9 Your Hunter fan comes with an integrated light fixture assembly and an optional switch housing. This feature gives you the option of installing the fan with or without the included light fixture.
-
Page 10: Operating Your Ceiling Fan
NOTE: Both plug connectors are polarized and will only fit Figure - Pull chain and reversing switch together one way. Make sure that both connectors are properly aligned before connecting them together. Incorrect connection could cause improper operation and damage to the product. 41865-01 01/15/2007 © 2007 Hunter Fan Company... -
Page 11: Troubleshooting
Turn power off, support fan very carefully, and check that the hanger ball is properly seated. If you need parts or service assistance, please call 888-830-1326 or visit us at our WEB site at http://www.hunterfan.com. Hunter Fan Company 2500 Frisco Avenue © 2007 Hunter Fan Company 41865-01 01/15/2007...