Table of Contents
Advertisement
Now turn the mixer ON. Once the application discovers the mixer it will check the firmware on the mixer and
report if it needs updating. Click NEXT to start the update. You will be asked to confirm that you want to proceed
click YES. A progress bar will then be shown as below.
Once complete (100%) the application will ask you to power the mixer OFF and then back ON again. Once the
keyboard lights on the mixer are steady again and the multi Preview image is shown from the mixer move onto
Stage 2 below.
Stage 2. Run the SE2000_SetUp_V2.3 program.
This second part of the update process and should also take 20 minutes to complete.
The mixer will still be connected with the sub D 9pin cable to the PC's COM1 port. Ensure the mixer is switched
ON. Double click the SE2000_SetUp_V2.3 program and on the first screen click on the reanimate button.
You will be asked to confirm that you want to proceed click YES. A progress bar will be shown, once finished
(100%) exit the application and power the mixer OFF and then switch it ON.
That is it, the new features or bug fixes should now be in place within the mixer.
26
Advertisement
Table of Contents
