Mounting Flanges; Section B: General Electrical Information; Recommended Power Supply Wire Specifications - Dimplex BFSL33 Installation Manual

MOUNTING FLANGES

!
NOTE: The trim should be in-
stalled before securing the firebox in
the opening.
There are two mounting flanges
located on each side of the fireplace
insert.
From the inside of the unit, bend tabs
outward and mount to the inside of
the framing using suitable hardware.

SECTION B: GENERAL ELECTRICAL INFORMATION

RECOMMENDED POWER SUPPLY WIRE SPECIFICATIONS

• For 120V installations
ground wire (3 wires total) for the incoming power supply on fireplace in-
serts. Use the appropriate wire to meet local and national electrical codes
for rated power consumption.
• For 208V / 240V installations
cable with ground wire (4 wires total) for the incoming power supply on
fireplace inserts. Use the appropriate wire to meet local and national elec-
trical codes for rated power consumption.
Two conductor, non-metallic sheath cable with ground wire (3 wires total) is
recommended for installation of a wall mounted thermostat and/or wall switch
for use on fireplace inserts. Use appropriate wire to meet local and national
electrical codes for rated power consumption. All wire gauges should match
the recommended wire sizes shown below.
120 Volts
208 Volts
240 Volts
use two conductor, non-metallic sheath cable with
Voltage
Figure 3
use three conductor, non-metallic sheath
Wire Gauge
12 Gauge
12 Gauge
12 Gauge
Fuse Rating
15 Amp
15 Amp
15 Amp
Mounting
Flanges
5