Flame Picture Adjustment - Jøtul Katahdin GI 450 DV II Installation And Operation Instructions Manual

Direct vent gas fireplace insert
Table of Contents

Advertisement

Flame Picture / Air Shutter
Adjustment
THIS APPLIANCE IS SHIPPED FROM THE FACTORY
EQUIPPED FOR USE WITH NATURAL GAS. IF
CONVERTING TO PROPANE, IT WILL BE NECESSARY TO
ADJUST THE AIR SHUTTER ON THE BURNER TUBE TO
ACHIEVE THE PROPER GAS TO AIR MIX. SEE FIG. 16.
WARNING:
AIR SHUTTER ADJUSTMENTS SHOULD ONLY BE PER-
FORMED BY A QUALIFIED PROFESSIONAL SERVICE
TECHNICIAN.
The air shutter adjustment can also help achieve
the desired flame appearance. Generally, flame appear-
ance is a matter of preference, however most people
enjoy a warm, yellowish flame.
Closing the Air Shutter - Insufficient combustion air
will result in very long yellow flames that can promote
soot. Sooting produces black deposits on the logs, on
the inside walls of the appliance, and potentially on the
exterior termination cap.
Sooting is caused by incomplete combustion in the
flames and lack of combustion air entering the air shut-
ter opening.
Opening the air shutter - will generate a flame
that is blue and transparent, or an "anemic" flame. This
flame is generally more efficient, but not very attractive.
Jøtul recommends the following settings for the
Katahdin gas insert:
Propane: 3/16" open
Natural Gas: 1/16" open
Run the insert for a minimum of 15 to 20 minutes for
an accurate representation of the flame appearance.
This should be done before and between any air
shutter adjustments.
To adjust the air shutter:
1. Loosen the air shutter stem wing nut located under
the firebox. See fig. 19.
2. Sliding the stem to the right opens the shutter and
increases air/fuel ratio. Sliding it to the left restricts
air flow and decreases the air/fuel ratio.
3. Allow insert to burn 30 minutes on the HIGH setting,
observing the flame continuously. Make further
adjustments in 1/8'inch increments and let the flame
settle-in before making subsequent adjustments.
4. If the flame appears weak, slow, or sooty, repeat the
process described above until the flame is as desired.
CLOSE
Figure 19. Air Shutter location.
139177_Rev_C July 11, 2010
OPEN
19

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents