Threading The Upper Thread; Needle Threader - Husqvarna Viking Sapphire 960Q User Manual

THREADING THE UPPER THREAD

the up position.
1. Place the thread on the spool pin and the spool cap on
the spool as described on page 2:4.
2. Spool pin in horizontal position:
Spool pin in vertical position:
Instead of bringing the thread into the pre-tension
4. Continue threading in the direction indicated by the
the
5. Take the thread down and behind the last guide just

NEEDLE THREADER

The needle threader allows you to thread the needle
automatically. The needle must be in the up position to use
the
the presser foot.
1. Use the handle to pull the needle threader all the way
down. The
needle eye.
3. Let the needle threader gently swing back. The hook
pulls the thread through the needle eye and forms
a loop behind the needle. Pull the thread loop out
behind the needle.
Note: The needle threader is designed to be used for size 70-120
needles. You cannot use the needle threader for needles size 60 or
smaller, the wing needle, twin needle, triple needle or when the Sensor
One-Step buttonhole foot is attached. There are also some optional
accessories that require manual threading of the needle.
When threading the needle manually, make sure that the needle is
threaded from front to back.
pre-tension
thread tension
D C
E
F
F
A
B
A
B
G
G
S U 2:5
ET P