Top Vent Enclosure; Alcove Enclosure - Napoleon BGD36CFNTR Installation And Operating Instructions Manual

36

6.3.2 TOP VENT ENCLOSURE

COMBUSTIBLE
MATERIAL
15"
*6 1/2" MIN
49"
COMBUSTIBLE

6.3.3 ALCOVE ENCLOSURE

Alcoves above the appliance can be
made as deep as desired as long as
the clearances to combustibles are
maintained as in 6.3.1 and 6.3.2. If
clearances to vent components are
reduced, materials must be non-
combustible.
W415-0899 / 06.01.10
COMBUSTIBLE
SHELF
1 1/2"
NON-
MATERIAL
STEEL
HEADER
REQUIRED
IF USING
OPTIONAL
CLEAN
FACE
34"
SURROUND
OR STYLO
GLASS
FACIA
(GD36M)
NON-COMBUSTIBLE
2"
0" IF NON-COMBUSTIBLE
FINISHING IS USED SUCH
2"
AS BRICK AND STONE
1"
43"
MINIMUM
PLUS RISE**
2"
NON-
COMBUSTIBLE
MATERIALS
ONLY
ALCOVE
AREA OVER
APPLIANCE
* If this appliance is installed
fl ush to the fi nishing material
and optional clean face surround
or Stylo glass facia is to be
installed then a minimum of 6
1/2" of cement board or non-
combustible equivalent must be
used on the top only of the front
face.
** See Venting Section
TOP
VENT
REAR
VENT