Quiz - GE SCA1000 Technical Service Manual

1. Which heaters will be operating when using a
preselected Speedcook setting?
a. The upper halogen only.
b. The upper and lower ceramic only.
c. The sheath and lower ceramic only.
d. The halogen, upper ceramic, and lower
ceramic only.
2. Sensor cooking is not available for how many
minutes following Speedcooking?
a. 3
b. 7
c. 5
d. 1
3. Voltage compensation occurs:
a. When using a preselected menu item in
Speedcook.
b. When using Oven/Bake to cook
conventionally.
c. Any time optimal voltage is not detected by
main PCB.
d. All of the above.
4. If the 12 amp fuse located on the sub PCB is
open, the symptoms will be:
a. A blank display.
b. The upper heaters will not operate.
c. The high voltage section will not energize.
d. None of the above.
5. Which components are one-time tripping
devices?
a. Magnetron TCO.
b. All TCOs.
c. Cavity TCO.
d. Hood TCO.

Quiz

6. Thermal protection is initiated at what
temperature?
a. 600° F.
b. 650° F.
c. 550° F.
d. 500° F.
7. The damper doors are open for:
a. Microwave cooking.
b. Speedcooking.
c. Oven/Bake cooking.
d. None of the above.
8. If the main PCB is receiving power but there is
no voltage at the CN1 terminal the most likely
cause would be:
a. Bad main PCB.
b. Bad low voltage transformer.
c. Blown 12 amp fuse on sub PCB.
d. Bad sub PCB.
9. Which heaters produce radiant heat?
a. Halogen only.
b. Sheath only.
c. Sheath and ceramic.
d. Halogen and ceramic.
10. Thermal compensation:
a. Only occurs when using the preselected
Speedcook menu.
b. Only once during Speedcook.
c. Will reduce the amount of time the heaters
are on in each duty cycle.
d. All of the above.
e. None of the above.
– 69 –