GE GFDN240 Owner's Manual page 30

Reversing the door swing.
STEP-BY-STEP INSTRUCTIONS (cont.)
Outer Door
Inner Door
Beauty Buttons
Tapping
Screws
Partially
Inserted
Screw
Tighten All
Screws
30
Reassemble Door Assembly
IMPORTANT: Make sure there is no dirt or any other foreign material in between
the window panes.
11. Place the plastic outer door onto the inner door. Make sure that the handle
part of the outer door is opposite the hinge as shown.
12. Turn the door over and fasten the outer door to the inner door using
the 6 tapping screws.
Move Strike Bracket
13. Using a putty knife or any other flat tool, remove the 3 beauty buttons located
on the dryer where the door will be installed and install them on the opposite side.
14. Switch the strike bracket and its cover to the opposite side by removing the screws.
Reinstall both on the opposite side.
Reinstall Door Assembly
15. The door is now ready to be installed on the dryer. To ease this step, the hinge
has keyholes that allow a partially fastened screw to be used as a hook.
Partially fasten a screw to the uppermost screw hole. Hook the door on the
partially fastened screw.
Fasten the hinge by installing the other 2 screws and tightening the partially
fastened screw above.