GE GFDN240 Owner's Manual page 28

Reversing the door swing.
STEP-BY-STEP INSTRUCTIONS (cont.)
Remove
Top Screw
8-#8 Tapping Screws
4 Beauty Buttons
6-# 8 Machine Tapping Screws
Outer Door Assembly
Hinge Cover
Hinge Assembly
28
Remove Door Assembly
2. Open the door to approximately 130 degrees.
3. Remove the 2 screws starting from the bottom to the top. Make sure the door
is supported while removing the screws.
4. Loosen the top screw as shown. Unhook the door by lifting and pulling.
5. Place the door on a soft protected flat surface so the inner door faces upward
(door resting on handle side). Remove the 8 tapping screws located around the
perimeter of the door outlining the gasket. Remove the 6 machine screws.
Using a putty knife or any other flat tool, remove the
them on the opposite side.
Remove Hinge and Cover
IMPORTANT: Note the location of the hinge (left or right) before removing.
6. With the screws removed, turn the door over and separate the outer door assembly
and hinge cover of the door from the door frame and set aside.
2 beauty buttons and install