Table of Contents
Advertisement
SECTION 2—ASSEMBLY
SECTION 2—ASSEMBLY
Unpacking the Patient Lift
Unpack the components from the shipping carton.
WARNING
Use only Invacare parts in the assembly of this
patient lift. The base legs, the mast, boom, pump
assembly and swivel bar are manufactured to
specifications that assure correct alignment of all
parts for safe functional operation.
Assembling the Mast Assembly to the
Base
NOTE: The mast assembly may be removed from the base for storage
or transporting. The mast assembly MUST be properly secured to the
base assembly before use.
NOTE: For this procedure, refer to FIGURE 2.1.
1.
Put the base on the floor.
NOTE: Make sure all four casters make contact with the floor.
2.
Lock both rear casters. Refer to Detail "A".
3.
Remove the hex bolt, washers and nut that are located in
the U-shape cut-out of the base.
4.
Lift the mast to an upright position.
5.
Lower the mast onto the mounting bracket.
6.
Check and tighten all hardware BEFORE use.
Stand Up Patient Lift
Step Here
DETAIL "A"
to Lock
Locking
Lever
UNLOCKED
Washer
Nut
FIGURE 2.1 Assembling the Mast Assembly to the Base
10
Step Here
to Unlock
LOCKED
Hex Bolt
Washer
Mounting Bracket
Part No. 1145811
Advertisement
Table of Contents
