Operation; General Transmitter Layout; Appliance Operation - Napoleon LHD50N Installation And Operating Instructions Manual

8.0 OPERATION

IF YOU DO NOT FOLLOW THESE INSTRUCTIONS EXACTLY, A FIRE OR EXPLOSION MAY RESULT
CAUSING PROPERTY DAMAGE, PERSONAL INJURY OR LOSS OF LIFE.
ALWAYS LIGHT THE PILOT WHETHER FOR THE FIRST TIME OR IF THE GAS SUPPLY HAS RUN OUT WITH
8.1

GENERAL TRANSMITTER LAYOUT

TRANSMISSION
THERMOSTAT CHILD SAFETY
OFF/ON/SMART
LOCK OUT
6
TEMPERATURE SET POINT/ LEVEL/ STATUS
FLAME
8.2

APPLIANCE OPERATION

• Install 4 AA batteries into the receiver battery bay as indicated on the battery cover (+/-). (Only required
8.2.1
as back up to household electricity).
While there is a provision to connect a 6V battery pack (do not use a 9 volt battery), it must not be
used when using the remote control receiver.
• Place the 3 position slider switch of the receiver in the "Remote" position.
8.2.2
• Using the end of a paper clip, or other similar object, insert the end of the paper clip into the hole
8.2.3
marked "PRG" on the receiver front cover. The receiver will "beep" three (3) times to indicate that it is
ready to synchronize with the transmitter.
• Install the 3 AAA batteries in the transmitter battery bay, located on the base of the transmitter.
8.2.4
With the batteries already installed in the transmitter, push the "ON" button. The receiver will "beep"
four times to indicate the transmitter's command is accepted and set to the particular code of that
transmitter. The system is now initialized.
THE GLASS DOOR OPENED OR REMOVED.
ROOM
LOW BATTERY
ALARM TEMPERATURE
FAN AUX. OUTPUT
35.1
WARNING
!
43
35.3
W415-0745 / B / 06.08.10