Low Battery / Manual Bypass; In The Event Of A Power Failure; Control Module; Anti Condensation Control Switch - Napoleon LHD50N Installation And Operating Instructions Manual

46

8.10 LOW BATTERY / MANUAL BYPASS

The life span of the remote batteries depends on various factors: quality of the
batteries, the number of ignitions, the number of charges to the room thermostat set
point, etc.
When the transmitter batteries are low, a Battery Icon will appear on the LCD
display before all battery power is lost. When the batteries are replaced this icon will
disappear.
Not applicable when plugged into 110V.
When the receiver batteries are low, no "beep" will be emitted from the receiver
when it receives an ON/OFF command. This in an alert for the receiver that there's low battery. When the
batteries are replaced the "beep" will be emitted from the receiver when the ON/OFF key is pressed.
If the batteries of the receiver or transmitter are low, the appliance can be turned on manually by sliding the
three position slider switch on the receiver to the "ON" position. This will bypass the remote control feature and
the appliance main burner will come on if the gas valve is in the "ON" position.

8.11 IN THE EVENT OF A POWER FAILURE

If the receiver is equipped with batteries they will enable fl ame height control, ON/OFF or thermostat
function to control the fi replace during a power failure. Refer to "FIREPLACE OPERATION" section when
communications between receiver and transmitter have been lost. The will receiver emit a "beep" sound to
confi rm programming has been successful once power is restored. During a power failure, if the fi replace was
on, the fl ame height will stay at the setting prior to the failure. If off when the failure occurs and then turned on,
the fl ame height will come on at "HI". The fl ame height can then be controlled by the remote.

8.12 CONTROL MODULE

The control module offers a remotely actuated 120V AUX
outlet for the accent lights and a constantly powered
120V outlet.
NOTE: Control module ON/OFF switch should
always be in the "ON" position. If for any reason the
module is turned "OFF", the components plugged
into the module won't have power.

8.13 ANTI CONDENSATION CONTROL SWITCH

This appliance has the option to go from an electronic intermittent
pilot ignition to a standing pilot for cold climates. The anti
condensation control switch (standing pilot) is located to the right of
the main viewing door frame (Operating Side). Using your fi nger
switch the pilot from one mode to the other.
W415-0745 / B / 06.08.10
ON
35.13
35.14
120V AUX OUTLET
CONSTANTLY POWERED
120V OUTLET
35.16
RIGHT SIDE OF
DOOR FRAME
(OPERATING SIDE)
ANTI CONDENSATION
CONTROL SWITCH
76
°F
MAINS VOLTAGE
SUPPLY CORD
MODULE ON/OFF
SWITCH (SHOWN IN
THE ON POSITION)
COMMUNICATION
BUS (3 PIN)