Adjusting The Seat Support Posts - Invacare ProntoTM M6 Owner's Manual

SEAT
Nut
F
R
O
N
T
R
I
Middle
Mounting
G
Hole
G
I
N
G
S
Nut
Top Mount-
ing Hole
FIGURE 5 - ADJUSTING THE SEAT HEIGHT - SEAT
ASSEMBLIES WITH SEAT SUPPORT COLLARS
HIGHEST POSITION
Mounting
Hole
Bolt
Seat Support
Collar
Seat Support Post
MIDDLE POSITION
Mounting
Hole
Bolt
Seat Support
Collar
Seat Support Post
LOWEST POSITION
Welded
Collar
No Seat Support
Collar Required
ADJUSTING THE SEAT SUPPORT
POSTS (FIGURE 6)
NOTE: If the retaining pin will NOT pass through the
seat mounting support AND through one (1) of the
three (3) height mounting holes in the seat support
post, perform the following steps:
1. Loosen, but DO NOT remove, the hex bolt
securing the seat support post to the seat
stand.
2. Grasp the seat support post and rotate it until
the height adjustment holes align with the
holes in the seat mounting support.
3. Keeping the holes aligned, tighten the hex bolt
securing the seat support post to the seat
stand.
4. If necessary, repeat STEPS 1-3 for the re-
maining seat support posts.
Seat
Support
Post
FIGURE 6 - ADJUSTING THE SEAT SUPPORT POSTS
23
PROCEDURE 5
Hex Bolt
Seat Stand
Height Adjustment
Holes
Rotate to
Align Holes
S
E
A
T