SECTION 11—RECLINER
Unlocked Position
NOTE: Illustration depicts two cables for dual tilt mechanisms. Locking mechanism engages/dise
in the same manner for single tilt mechanism.
Non-recliner Models
Operating Recliner
Pinch Points exist between spreader bar and gas cylinders. Use caution, otherwise
injury may occur.
NOTE: For this procedure, refer to FIGURE 11.2 on page 73.
1. Make sure the wheelchair is on a level surface.
2. Engage the wheel locks. Refer to Hand Activated Wheel Lock Procedures on page 66
or Foot Activated Wheel Lock Procedures on page 65.
3. Inform the occupant of the wheelchair that the wheelchair is about to be reclined.
4. Stand behind the wheelchair and grasp the stroller handle firmly.
5. Pull up on the handles of the recliner cable assemblies to activate the gas cylinders.
6. Slowly, squeeze the handles of the recliner cable assemblies and allow the back to
recline to the desired angle.
™
Orbit
Wheelchair
Frame
(DISENGAGED)
FIGURE 11.1 Engaging Tilt-In-Space
WARNING
Release
Pedal
Locked Position
(ENGAGED)
Recliner Models
72
Part No. 1073955