Typical Product Parameters - Invacare Orbit 1073955 Owners Operating & Maintenance Manual

TYPICAL PRODUCT PARAMETERS

TYPICAL PRODUCT PARAMETERS
OVERALL WIDTH:
OVERALL DEPTH
(WITHOUT FRONT RIGGINGS)
SHORT FRAME:
LONG FRAME:
SEAT WIDTH:
SEAT DEPTH:
FRAME TYPE:
SEAT-TO-FLOOR*:
BACK STYLE:
BACK HEIGHT:
BACK ANGLE (RECLINER ONLY):
ARM STYLES:
FOOTREST:
REAR AXLE:
REAR AXLE MOUNTING PLATES:
REAR WHEELS:
HANDRIMS:
CASTER SIZE:
WHEEL LOCKS:
WEIGHT:
SHIPPING WEIGHT** (APPROX.):
*NOTE: Invacare recommends that rear seat‐to‐floor height be at least 3/8 inch shorter than front
seat‐to‐floor height. Otherwise a forward seat dump can occur. The rear seat‐to‐floor heights are
based on pneumatic tires or pneumatic tires with flat free inserts. If wheelchair is equipped with
urethane tires, subtract 1/4 inch from the measurements listed above. All heights are approximate
to ± 1/4 inch due to tire wear and air pressure. The front seat‐to‐floor heights are approximate to ±
1/4 inch.
**NOTE: Weights vary depending on how wheelchair is equipped.
™
Orbit
ORBIT
MINIMUM
18.5 inches
35 inches
39 inches
10-16 inches (in one inch increments)
10-16 inches (in one inch increments)
Aluminum, One-piece
15-1/2 to 20-1/2 inches
Adjustable Angle (80° to 110°), Fold Down Reclining back
with stroller handles (Available on long frames only),
Fixed Height Anodized Cane with Push Handles
20 inches
90° to 170°
"T" (Standard), Cantilever (Fixed Hgt. Anodized Cane with
Push Handles Only) or Dual Point (Adjustable Height)
Swingaways Footrests and Elevating Legrests
Permanent or Quick Release
Multi-Position
12, 20, 22 and 24 inch Composite Pneumatic or
Pneumatic-Flat Free Insert, Urethane tires
Aluminum, Plastic Coated and Projection
5 inch Aluminum or Composite Urethane, 6 or 8 inch
Composite Urethane, Pneumatic or Pneumatic with
Flat Free Insert
Push-to-Lock, Wheel Lock Extensions, Hill Holder,
Foot Activated
32 lbs without front riggings
12
MAXIMUM
24.5 inches
38 inches
42 inches
45 lbs
Part No. 1073955