Table of Contents
Advertisement
LX-P1010ZU/ZE
2 DISASSEMBLY/ASSEMBLY PROCEDURES
2.1. DISASSEBLY FLOWCHART OF
CABINET PARTS
This flowchart indicates the disassembly steps of the cabinet parts
and the P.W. Boards. When reassembling, perform the step(s) in
the reverse order.
2.2. DISASSEMBLY METHOD OF
CABINET PARTS
2.2.1. Removal of the Lamp Cover Unit
1. Loosen 2 screws (A) as shown in Fig. 2-2-1.
5 (PA014)
Fig. 2-4-1
Fig. 2-2-1
2.2.2. Removal of the Bottom Case Unit
1. Remove 4 screws (B), 6 screws (C) and a screw (D) as shown
in Fig. 2-2-2.
Fig. 2-2-2
2. Carefully pull the Tab (A) side of the Bottom Case Unit as shown
in Fig. 2-2-3.
3. Carefully remove the Bottom Case Unit with paying attention
to the Tab (B).
Fig. 2-2-3
Assembly Note:
When removing the bottom Case Unit, be sure to remove the
Lamp Cover Unit first.
If it is assembled without removing the Lamp Cover Unit, the
Interlock switch of the Main PWB will be damaged. (If it is
damaged, the Projector won't operate and the indication of it
is "C-0".)
Advertisement
Table of Contents
