Removal Of The Optical Unit - JVC LX-P1010ZU Service Manual

2.2.9. Removal of the Optical Unit

1. Remove the Main Grounding Plate as shown in Fig. 2-2-12.
2. Carefully pull out the Optical Unit.
Fig. 2-2-12
3. Remove a screw (H) as shown in Fig. 2-2-13 and remove the
Lamp Connector.
Fig. 2-2-13
Assembly Note:
1. Twist the Lamp Connector cable 3 times on the right and insert
in the original position as shown in Fig. 2-2-13.
2. When installing the Lamp Connector, be careful of the direction
of the insertion as shown in Fig. 2-2-13.
3. Before installing the Optical Unit, be sure to remove the Filter
Cover first. If it is installed without removing the Filter Cover,
the Filter Switch may be damaged.
4. When installing the Optical Unit, make sure that the position of
portion (a) is at the fuse (F1102) and pay attention not to nip
the connector cable of P1151 under the Optical Unit as shown
in Fig. 2-2-12.
LX-P1010ZU/ZE
(PA014) 8