Installing 3 Wire Power Cord; Installing 4 Wire Power Cord - Amana ARTSC8650 Series Owner's Manual

Installing 3 Wire Power Cord

1. Remove rear wire cover.
2. Place strain relief (winged clamp) in cord access hole
below terminal block.
• Place wings through hole, entering from bottom.
• Screw holes in clamp should be below mounting
panel.
3. Place cord through strain relief.
• Attach neutral (center) or white wire to center
terminal on terminal block.
4. Attach power lead, red wire or black wire to left side
power terminal.
5. Attach power lead, red wire or black wire to the right
side power terminal.
6. After wires have been placed on terminals, attach with
hex nuts provided.
• Firmly tighten to insure proper electrical
connection.
7. Place screw through strain relief and tighten.
8. Replace rear wire cover.

Installing 4 Wire Power Cord

POWER LEAD
connect wire with black or
red insulation and brass
terminal
POWER TERMINALS
(240 VOLTS)
WARNING
To avoid the risk of severe electrical shock or death,
ground wire must be attached to frame of range,
using ground screw provided. Ground wire must not
contact any other terminal.
1. Remove rear wire cover.
2. Place strain relief (winged clamp) in cord access hole
below terminal block.
• Place wings through hole entering from bottom.
• Screw holes in clamp should be below mounting
panel.
3. Remove grounding strap attached to center terminal
on terminal block.
• Strap is not needed for this installation.
• Remove green ground screw and retain for use in
step 7.
4. Place cord through strain relief.
• Attach cord neutral (center) or white wire to center
terminal on terminal block.
5. Attach power lead, red wire or black wire to left
terminal.
6. Attach power lead, red wire or black wire to right
terminal.
7. Attach green or bare wire to back of range using
green ground screw previously removed in step 3.
8. Attach wires using hex nuts provided.
• Firmly tighten to insure proper electrical
connection.
9. Place screw through strain relief, tighten, and replace
rear wire cover.
9
NEUTRAL TERMINAL
connect wire with white
insulation
POWER LINE
connect wire with black or
red insulation and brass
terminal