Section 2-Assembly; Attach The Mast To The Base Assembly - Invacare GET-U-UP LIFT Maintenance Manual

SECTION 2—ASSEMBLY
SECTION 2—ASSEMBLY
Each time the mast is removed and assembled to the base assembly, the mast MUST be locked
into the socket of the base assembly.

Attach the Mast to the Base Assembly

NOTE: For this procedure, refer to FIGURE 2.1.
1. Remove the locking screw from the base assembly.
2. Match the notch at the bottom of the mast with the tabs inside the socket of the base assembly.
3. Insert the mast into the socket and onto the tabs.
4. Try to turn the mast.
NOTE: If the mast turns in the socket, repeat STEPS 2 and 3 until proper alignment is obtained.
5. If the mast does not turn in the socket, insert the locking screw into the base and tighten securely.
™
Get-U-Up Lift
WARNING
Side view of the Base Assembly and Mast
Notch
Locking Screw
FIGURE 2.1
Attach the Mast to the Base Assembly
Mast
Socket
Tab
10
Part No 1148115