Table of Contents
Advertisement
ASSEMBLY OF THE PATIENT LIFT
WARNING
Use ONLY Invacare parts in the assembly of this
patient lift. The base legs, the mast, boom, pump
assembly and the swivel bar are manufactured to
specifications that assure correct alignment of all
parts for safe functional operation.
Unpacking the Patient Lift
1. Unpack the components from the shipping carton.
2. Cut the tie-wraps that secure swivel bar to the base
and the pump assembly to the mast (FIGURE 1).
Tie-Wrap
FIGURE 1 - UNPACKING THE PATIENT LIFT
Assembling the Mast to the Base
1. Lock casters (FIGURE 2).
LOCK
FIGURE 2 - LOCKING THE CASTERS
2. Remove the covers, pivot bolt, nut and washers,
located at the base of the mast (FIGURE 3).
ASSEMBLY
FIGURE 3 - REMOVING PIVOT BOLT
NOTE: The connection between the mast and the
base should be cleaned and coated with
petroleum jelly prior to assembly.
3. Position the mast bushings into the U-shaped
cut-out of the base while pushing the mast into an
upright position (FIGURE 4).
4. Insert pivot bolt with washers through the base and
mast bushing. Secure with nut (FIGURE 4).
5. Align adjustment knob flush with the lip of the
U-shaped cut-out of the base (FIGURE 4).
NOTE: This will prevent the mast from
disengaging from the base.
The mast may be removed from the base for
storage or transporting. Each time the mast is
removed and returned to the base, the mast MUST
be properly secured to the base assembly.
Adjustment
Knob
UNLOCK
FIGURE 4 - SECURING MAST TO BASE
9
ASSEMBLY
WARNING
U-shaped
cut-outs
Mast
Bushing
A
S
S
E
M
B
L
Y
Advertisement
Table of Contents
