Maintenance And Care; Cleaning Air Filter; Check Fuel System; Replacing Fuel Filter - Shindaiwa BP35 Owner's Manual

Brushcutter
Hide thumbs Also See for BP35:
Table of Contents

Advertisement

Available languages

Available languages

If you have any questions or problems, please contact your shindaiwa dealer.

Cleaning air filter

NOTE
If filter is excessive dirty or no longer fits properly, replace it.
1. Three screws.
2. Air cleaner cover.
Close choke.
Loosen three screws and remove air cleaner cover first, and then air filter.
Brush dirt from filter or wash it in a suitable cleaner.
Dry it completely before installation.
Reinstall the air filter and air cleaner cover, and then tighten three screws.

Check fuel system

Check before every use.
After refuelling, make sure fuel does not leak or exude from around fuel pipe, fuel grommet
or fuel tank cap.
In case of fuel leakage or exudation there is a danger of fire.
Stop using he machine immediately and request your dealer to inspect or replace.

Replacing fuel filter

1. Fuel tube.
2. Fuel filter.
Drain all the fuel from the fuel tank.
Pull apart the fuel tube at the joint and remove the fuel filter to clean or replace as
necessary.

Check spark plug

∗ Spark plug gap: 0.6 to 0.7 mm
Check plug gap.
Correct gap is 0.6 to 0.7 mm.
Inspect electrode for wear.
Inspect insulator for oil or other deposits.
Replace plug if needed and tighten to 15 - 17 N•m (150 to 170 kgf•cm).

Cooling system maintenance

IMPORTANT
To maintain proper engine operating temperature, cooling air must pass freely through the
cylinder fin area.
This flow of air carries combustion heat away from the engine.
Overheating and engine seizure can occur when:
Air intakes are blocked, preventing cooling air from reaching the cylinder,
or
Dust and grass build up on the out side of the cylinder.
This build-up insulates the engine and prevents the heat from leaving.
Removal of cooling passage blockages or cleaning of cylinder fins is considered "Normal
Maintenance".
Any resultant failure attributed to lack of maintenance is not warranted.
1. Cylinder fins.
2. Air intake.
Remove dust and dirt from between fins.
Before each use, remove accumulated debris from bottom engine intake grille.

Maintenance and care

3. Air filter.
24

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents