Installing/Removing The Axle Bolt - Invacare 9000 Service Manual

PROCEDURE 3
INSTALLING/REMOVING THE AXLE
BOLT (FIGURE 4)
Installing
R
1. If necessary, install rear wheel onto transmission rear
hub. Refer to INSTALLING/REMOVING THE REAR
E
WHEEL TO/FROM THE TRANSMISSION REAR
A
HUB in this procedure of the manual.
R
2. Insert axle bolt through rear wheel bearing.
3. Slide inner hub spacer, axle washer and outer hub
W
spacer over axle bolt.
H
E
E
L
Rear Wheel
Bearing
Axle Bolt
T
R
A
N
Pan Head Screw
S
M
I
S
S
I
O
N
Rear Wheel
Bearing
Axle Bolt
Pan Head Screw
FIGURE 4 - INSTALLING/REMOVING REAR WHEEL TO/FROM TRANSMISSION REAR HUB -
INSTALLING/REMOVING THE HUB SUPPORT PLATES - INSTALLING/REMOVING THE AXLE BOLT
Wheelchairs Built BEFORE 09/05/00
Axle Washer
Rear Wheel
Hub Spokes
Hub Support Plate
Wheelchairs Built AFTER 09/05/00
Axle Washer
Rear Wheel
Hub Spokes
Hub Support Plate
REAR WHEEL/TRANSMISSION
4. Secure axle bolt to wheelchair side frame with hex
nut. Tighten securely.
Removing
1. Remove hex nut securing axle bolt to wheelchair side
frame.
2. Remove axle bolt from wheelchair side frame.
3. Remove inner hub spacer, axle washer and outer hub
spacer from axle bolt.
4. Remove axle bolt from rear wheel bearing.
Outer
Hub
Spacer
Inner Hub Spacer
Transmission Rear Hub Slot
Transmission Rear Hub
Outer
Hub
Spacer
Inner Hub Spacer
Transmission Rear Hub Slot
Transmission Rear Hub
10
Wheelchair
Side Frame
Hex Nut
Transmission
Assembly
Wheelchair
Side Frame
Hex Nut
Transmission
Assembly