Table of Contents
Advertisement
The Fax Machine
3−8
Receiving in AUTO Mode
Before receiving in AUTO Mode, you have to set the machine
to AUTO Mode by pressing Rcv. Mode/Contrast repeatedly
!
until '
AUTO MODE' is displayed.
•
In Standby Mode, AUTO appears in the right hand
corner of the display.
•
When a call comes in, the machine answers it. If a fax
is being received, the machine goes into receive mode.
If the machine does not sense a fax signal, it will con−
tinue ringing to tell you it is a phone call. You should
pick up the handset to answer the call, or it will switch
to automatic reception mode, after approximately 25
seconds.
Receiving in TAM Mode (SF−3200)
Before receiving in TAM Mode, you have to set the machine
to TAM Mode by pressing Rcv. Mode/Contrast repeatedly
!
until '
TAM MODE' is displayed.
•
In Standby Mode, TAM appears in the right hand cor−
ner of the display.
•
When a call comes in, the answering machine answers
and stores the caller's message if they leave one. If the
machine detects a fax signal, it goes into receive mode.
•
If you have set your machine to TAM Mode and your
answering machine is switched off, or the answering
machine is not connected to your fax machine, the
machine will automatically go into receive mode after
several rings.
•
If your answering machine has a 'User−Selectable
Ring Counter', set the machine to answer an incoming
call in less than four rings.
•
If the sound level of the call is too low due to a poor
phone connection, the fax machine or answering
machine may not work properly.
•
When you set the machine to TEL Mode and you have
an answering machine attached, you must make sure
you switch off the answering machine, or, the outgoing
message will interrupt your phone conversation. Not
all answering machines will work with your fax
machine.
•
When your answering machine answers an incoming
call, it records a fax tone until it realizes it is a fax
Advertisement
Table of Contents
