Panasonic DMC-FT5EB Service Manual page 20

3. Error Code List
The error code consists of 8 bits data and it shows the following information.
Attribute Main item Sub item
LENS Lens drive OIS
Zoom
Focus
Lens
Error code
High Low 4
4bits bits
18*0 1000 PSD (X) error. Hall element (X axis) position detect error in
OIS unit.
OIS Unit
2000 PSD (Y) error. Hall element (Y axis) position detect error in
OIS unit.
OIS Unit
3000 GYRO (X) error. Gyro (IC7101) detect error on Main P.C.B.
IC7101 (Gyro element) or IC6001 (VENUS ENGINE)
4000 GYRO (Y) error. Gyro (IC7101) detect error on Main P.C.B.
IC7101 (Gyro element) or IC6001 (VENUS ENGINE)
5000 GYRO (R) error. Gyro (IC7101) detect error on Main P.C.B.
IC7101 (Gyro element) or IC6001 (VENUS ENGINE)
6000 Drive voltage (X) error.
LENS Unit, LENS flex breaks, IC6001(VENUS ENGINE)
AD value error, etc.
7000 Drive voltage (Y) error.
LENS Unit, LENS flex breaks, IC6001(VENUS ENGINE)
AD value error, etc.
8000 OIS GYRO - Digital communication error.
IC7101 (Gyro element) or IC6001 (VENUS ENGINE)
0?10 Collapsible barrel Low detect error
(Collapsible barrel encoder always detects Low.)
Mechanical lock, FP9002-(40) signal line or IC6001
(VENUS ENGINE)
0?20 Collapsible barrel High detect error
(Collapsible barrel encoder always detects High.)
Mechanical lock, FP9002-(40) signal line or IC6001
(VENUS ENGINE)
0?30 Zoom motor encoder error.
Mechanical lock or IC6001 (VENUS ENGINE)
0?40 Zoom motor encoder error. (During monitor mode.)
Mechanical lock or IC6001 (VENUS ENGINE)
0?50 Zoom motor encoder error. (During monitor mode with
slow speed.)
Mechanical lock or IC6001 (VENUS ENGINE)
0?60 The zoom position jump is detected due to the impact (i.e.
drop.) to the camera occurs.
Lens unit
0?01 HP High detect error
(Focus encoder always detects High, and not becomes
Low)
Mechanical lock, FP9002-(40) signal line or IC6001
(VENUS ENGINE)
0?02 HP Low detect error
(Focus encoder always detects Low, and not becomes
High)
Mechanical lock, FP9002-(40) signal line or IC6001
(VENUS ENGINE)
10*8 0000 Lens cap error
Zoom motor, zoom pulse encoder 2
18*1 0000 Power ON time out error.
Lens drive system
18*2 0000 Power OFF time out error.
Lens drive system
Contents (Upper)
Check point (Lower)
20
Error Indication
Detecting Part/Circuit
device
OIS X LENSu NG
OIS Y
GYRO X GYRO NG
GYRO Y
GYRO R
OISX REF LENSu/LENS
FPC
OISY REF
(No indication) (No indication)
ZOOM L ZOOMm/
LENSu
ZOOM H
ZOOM ENC
(No indication) (No indication)
FOCUS L LENS FPC/
DSP
FOCUS H
(No indication) (No indication)
LENS DRV LENSu