Appliance Setup; Remove Fixed Glass Assembly; Remove The Shipping Materials; Clean The Appliance - Heatilator GDST5244I Owner's Manual

15

Appliance Setup

A. Remove Fixed Glass Assembly
See Section 15.H.
B. Remove the Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
C. Clean the Appliance
Clean/vacuum any sawdust that may have accumulated
inside the firebox or underneath in the control cavity.
D. Accessories
Install approved accessories per instructions included
with accessories. Contact your dealer for a list of ap-
proved

accessories.

WARNING! Risk of Fire and Electric Shock! Use ONLY
Hearth & Home Technologies-approved optional acces-
sories with this appliance. Using non-listed accessories
could result in a safety hazard and will void the warranty.
E. Install the Log Set
• The bottom logs are fastened to the gate assembly and
have pins and grooves for top log placement.
• See Figure 15.1 for top log identification.
7
6
11
Description
6 Middle Log
7 Top - Left Log
8 Top - Middle, Back Log
9 Top - Right, Back Log
10 Top - Right, Front Log
11 Top - Left, Front Log
Figure 15.1 Log Identification
8
9
10
Heatilator • GDST5244I • 4045-127 • Rev Z • 08/09
P3 P1
P9
Figure 15.2 Bottom Logs (shipped in place)
• Log placement as seen from the valve side of the
appliance. See Figure 15.2.
• Place logs in order as shown in Figures 15. through
15.8. The completed log set is shown in Figure 15.9.
Holes in top logs correspond to pins in bottom log set
(Figure 15.2)
Figure 15.3 Middle Log (#6) Placed on Pins P1 & P2
P4 P5 P6 P7
P2
P8
Valve
45