Power Management Setup - Xycom SBC-370 Board Processor Manual

POWER MANAGEMENT SETUP

Power Management/APM >:
Green PC Monitor Power State >:
riod of display-idle has ended.
Video Power Down Mode >:
the specified period of display-idle has ended.
Hard Disk Power Down Mode >:
riod of hard drive-idle has ended.
Standby Time Out (Minute) >:
in full power-on state. After this period of time has ended, the system will go into
Standby state.
Suspend Time Out (Minute) >:
Standby state. After this period of time has ended, the system will go into Suspend state.
Throttle Slow Clock Ratio >:
The figure is a ratio between power conserving and normal state CPU clock.
Modem Use IO Port >:
Modem Use IRQ >:
Display Activity >:
Used to monitor or ignore specified device IRQs.
Device X >:
Enables or disables the Advanced Power Management feature.
Specify the power state of the monitor after the specified pe-
Specify the power state of the VESA VGA video subsystem after
Specify the power state of the hard disk after the specified pe-
Specify the length of the system-idle period while the system is
Specify the length of the system-idle period while the system is in
Specify the speed of the system clock under power saving state.
Assign a port for modem.
Assign an IRQ for modem.
Specify if the BIOS should monitor display activity or not.
AMI BIOS Setup Menus 32