Short Plug Settings; Printing Singly Using Controller-Equipped Printer - Oki C9400 Maintenance Manual

3.2

Short Plug Settings

The SWA board has two short plugs that can be set as follows:
Short Plug (WE1)
Sets flash ROM DIMM to connect WE signals.
(1-2 Short: Disconnects WE signals; 2-3 Short: Connects WE signals.)
The factory-shipped short plug is set to the 2-3 short: Re-programmable the Flash ROM DIMM.
Short Plug (WE2)
(Not use)
3.3

Printing Singly Using Controller-Equipped Printer

Menu Map Printing
Prints the program versions, controller block, and other printer configuration and settings.
Operation: (Press of Switch)
Without HDD: "0" → "3" → "3"
With HDD: "0" → "0" → "3" → "3"
File List Printing
Prints a list of files stored on a HDD or in ROM.
Operation: (Press of Switch)
Without HDD: "0" → "3" → "1" → "3"
With HDD: "0" → "0" → "3" → "1" → "3"
Font List Printing (PCL)
Prints a list of PCL fonts.
Operation: (Press of Switch)
Without HDD: "0" → "3" → "1" → "1" → "3"
With HDD: "0" → "0" → "3" → "1" → "1" → "3"
Font List Printing (PS)
Prints a list of PS fonts.
Operation: (Press of Switch)
Without HDD: "0" → "3" → "1" → "1" → "1" → "3"
With HDD: "0" → "0" → "3" → "1" → "1" → "1" → "3"
Demo Printing
Prints the demo patterns for destinations.
Operation: (Press of Switch)
Without HDD: "0" → "3" → "1" → "1" → "1" → "1" → "3"
With HDD: "0" → "0" → "3" → "1" → "1" → "1" → "1" → "3"
Ethernet Board Self-Diagnostic Printing
When equipped with an Ethernet board, the printer runs diagnostic checks on itself by holding
the SW on the Ethernet board down for two seconds or more, and prints the results.
41388601TH Rev.6
Oki Data CONFIDENTIAL
63 /