Connecting The Remote Zone (Zone 2) Speakers; When Using The Surr Back/Zone 2 Speakers Terminals; When Using The Surr Back/Zone 2 Pre Out Terminals; When Using The Zone 2 Out Terminals - Integra DTR-7.3 Instruction Manual

Connecting the remote zone (Zone 2) speakers

The DTR-7.3 allows you to watch and listen to two separate input
sources at the same time. This allows you to, for example, place
speakers and a television in two different rooms so that two or more
people can enjoy two different movies at the same time. The room
where the DTR-7.3 is actually located is referred to as the main room
while the separate room is referred to as the remote zone (Zone 2). In
addition, the IR IN/OUT terminal of the DTR-7.3 allows you to
control the DTR-7.3 from the remote zone (Zone 2) with the remote
controller even though the remote zone is physically separated. The
diagram below shows how to make the proper connections for the
remote zone.
When using the SURR BACK/ZONE 2 SPEAKERS
terminals
If you are using a 5.1-channel speaker system in the main room, you
can connect the speakers for the remote zone (Zone 2) to the open
SURR BACK/ZONE 2 SPEAKERS terminals.
With this connection, select "Zone 2" for the Hardware Setup →
Surr Back/Zone2 → Surr Back/Zone 2 setting in the Setup menu (see
page 42).
Main Room
SURR
BACK/
ZONE 2
SPEAKERS
L
R
DTR-7.3
Note:
It is important to be aware of the speaker impedance (see page 41).
When using the SURR BACK/ZONE 2 PRE OUT
terminals
If you are using a 5.1-channel speaker system in the main room, you
can connect the amplifier for the remote zone (Zone 2) to the open
SURR BACK/ZONE 2 PRE OUT terminals and connect the remote
zone speakers.
With this connection, select "Zone 2" for the Hardware Setup →
Surr Back/Zone 2 → Surr Back/Zone 2 setting in the Setup menu
(see page 42).
24
Remote Zone (Zone 2)
Zone 2 Zone 2
Left Right
speaker speaker
Main Room
PRE OUT
R L
FRONT
SUB CENTER
SURR
SURR
R L
BACK/
ZONE 2
Left (white)
DTR-7.3 Right (red)

When using the ZONE 2 OUT terminals

When you have connected all the speakers for 7.1-channel audio in
the main room, connect the speakers as shown below.
The ZONE 2 OUT terminal is a constant output. Connect to the
LINE input of the amplifier (CD, tape, etc.). Adjust the volume with
the amplifier connected to the ZONE 2 OUT terminal.
1. Connect the DTR-7.3 to the amplifier for the remote
zone.
2. Connect the remote zone speaker cables to the
speaker terminals on the amplifier.
3. Connect the DTR-7.3 to the monitor for the remote
zone.
Remote Zone (Zone 2)
Zone 2
Left speaker
Zone 2 amplifier
Right (red)
Left (white)
Note:
The ZONE 2 out terminals of the DTR-7.3 are of a fixed output
level.
Remote Zone (Zone 2)
Zone 2 Zone 2
Left Right
speaker speaker
Power amplifier
Zone 2 monitor Zone 2
or projector Right speaker
Main Room
VIDEO
AUDIO S VIDEO
MONITOR
OUT
R L
OUT ZONE 2
DTR-7.3