Table of Contents
Advertisement
PROBLEM
Other disc errors
(DVD+RW)
Other disc errors
(DVD+R), 'Disc
contains unknown
data' interruption of a
recording (power
outage)
The index screen
flickers when a DVD+R
is inserted
I have forgotten the
PIN Code
SOLUTION
b
If it is impossible to play back a disc, you can try and repair it for new recordings using the following function.
This will only prepare the disc for erasing. It will not be erased, however, until the recording has been
completed.
1
Clean the disc
Open the disc tray with OPEN/CLOSE J . Insert the disc but do not close the tray.
2
3
Hold down the red function button on the remote control until the tray closes. The disc is
prepared for erasing.
4
Start recording as with an empty disc.
b
This message may appear if you instert a DVD+R that was not finalised or an error occurs during the
recording. DVD+R's that have not been finalised are very sensitive to fingerprints, dust, or dirt. This may
cause problems during recording.
To use the disc again, follow the next steps
1
Make sure that the surface of the disc is clean.
Open the disc tray with OPEN/CLOSE J . Insert the defect DVD+R but do not close
2
the tray.
3
Hold down 5 on the remote control until the tray closes. The disc will be read ('READING'
appears on the display) and the DVD recorder will start the repair process. This may take up
to four times as much time as the recording, in which the error occurred.
4
If the disc is recovered, the index screen will appear.
Please observe the following:
The recovering procedure is successfully only if there was a previous recording on the disc.
Error during recording: The title may be missing.
Error while changing the title/index picture: The original title/index picture may be visible.
Error while finalising: The disc appears not to have been finalised.
b
You can finalise the disc using the following function:
1
Open the disc tray with OPEN/CLOSE J . Insert the defect DVD+R but do not close
the tray.
2
Hold down 4 on the remote control until the tray closes.
'FINALIZING' appears in the display. Finalising begins. This may take up to three minutes.
3
If finalising has been successful, the index screen will appear.
b
To erase the PIN code (reset to 0000), proceede as follows:
1
First press DISC MENU then SYSTEM MENU .
2
Select the symbol '
A
Confirm the line 'Access control' using C and pree 4 times STOP h on the remote
3
control. The PIN code is reset to '0000'.
4
End with SYSTEM MENU
Before you call an engineer
' using D , select '
(Disc features)' using B and confirm with C .
s
77
Advertisement
Table of Contents
