Table of Contents
Advertisement
Additional installation features
Manual TV channel search
In some cases, not all of the available TV channels may have been found
and stored during initial installation. In this case, you will need to search
for and store the missing or coded TV channels manually.
Preparation:
•) Switch on the TV set, and if necessary, select the programme number for the
DVD recorder.
•) Switch on the DVD recorder.
1 Press the DISC MENU button and then the SYSTEM
MENU button on the remote control.
P
The 'SYSTEM MENU' appears.
2 Select 'Set up' using B .
3 Press C to select 'System'.
4 Select the line 'Installation' using B and confirm with C .
P
A message appears on the screen that the change of this
setting will flush the 'Time Shift Buffer'.
O
If the 'Time Shift Buffer ' contains important recordings, save
them with the REC/OTR n button first. Read additional
information to the 'Time Shift Buffer' in the chapter 'The Time
Shift Buffer'.
5 Select 'Yes' with D and confirm with OK .
O
If the message window was closed, confirm the line with
C again.
6 Select 'Manual search' using B or A and confirm with C .
Installation
Manual search
Channel/freq.
Entry/search
Programme number
TV channel name
Decoder
TV system
NICAM
Fine tuning
7 In 'Channel/freq.', select the desired display using C .
'Freq.'(Frequency), 'CH'(Channel), 'S-CH'(Special/hyperband
channel)
8 In 'Entry/search', enter the frequency or channel of the TV
station using the number buttons 0..9 .
Press C in the line 'Entry/search' to start the automatic
O
search.
P
A changing channel number/frequency number will appear on
the TV screen.
Continue the automatic search until you have found the TV
channel you are looking for.
9 Using D or C in 'Programme number', select the programme
number you want to use for the TV channel, e.g. '01'.
22
0 Press OK to store the TV channel.
A To search for other TV channels, begin again at
B To end, press SYSTEM MENU .
CH
01
01
BBC1
Off
PAL-BG
On
0
To store
Press OK
O
Change the name of a TV channel:
- In 'TV channel name', press C .
- Select the desired character position using D or C .
- hange the character at the desired position with B or A .
- Select the next character position in the same way.
- Confirm with OK .
O
'Decoder'
No function. This setting should remain 'Off'. Otherwise it is
not possible to receive TV channels.
O
Change the TV system of the TV channel:
- In 'TV system', use D or C to select the TV system that
produces the least distortion of picture and sound.
O
NICAM
- If reception is poor and the sound distorted you can turn off
NICAM.
In 'NICAM', select 'Off' using C .
O
Fine tuning
- You can try fine tune the TV channel manually with D ,
C in the line 'Fine tuning'.
8
.
Advertisement
Table of Contents
