InSinkErator WASTEXPRESS 14481 User Manual page 18

PROBLEM
Waste Xpress stops unexpectedly.
Water exits Waste Xpress
at front of cabinet.
Waste Xpress does not run,
but disposer and water run.
No water spraying onto
auger screen.
Water fl ows continuously before
controls are turned on.
Overload protector trips frequently.
Troubleshooting
SYSTEM TROUBLESHOOTING
POSSIBLE CAUSE
•
Discharge chute misaligned.
•
Fuse blown or circuit breaker
tripped at power source.
•
Stop button on control center
has been pushed.
•
Drain line has clog.
•
High water level.
•
Contactor defective.
•
Auger motor defective.
•
Solenoid valve clogged.
•
Water turned off.
•
Solenoid valve defective.
•
Spray nozzles clogged.
•
Timer defective.
•
Timer not set properly.
•
Solenoid valve installed incorrectly.
•
Solenoid valve installed incorrectly.
•
Timer is not set properly.
•
Solenoid valve is defective.
•
Disposer is overloaded with
food waste.
19
SOLUTION
•
Reinstall discharge chute to ensure
proper fi t.
•
Replace fuse or reset circuit breaker.
•
Push start button on control center.
•
Clear drain.
•
Add second waste outlet drain connect from
Waste Xpress cabinet to sewer connection
(recommended for trough applications).
•
Call service.
•
Call service.
•
Remove clog.
•
Turn on water.
•
Call service.
•
Replace nozzles.
•
Call service.
•
Call service.
•
Reinstall solenoid valve so arrow is pointing
in correct direction.
•
Reinstall the water solenoid valve with the
arrow on the valve pointing in the direction
of the water fl ow.
•
Call service.
•
Replace solenoid valve.
•
Do not overload disposer with excessive
amounts of food waste.