Page 1
NOTICE is used to address practices related to physical injury Please be certain that the person who installs or uses this appliance carefully reads and understands the Safety Instructions contained in this manual. www.insinkerator.com/foodservice Part No. 13954 Rev.B...
Introduction Read all warnings before proceeding. INTRODUCTION TYPICAL INSTALLATION The InSinkErator Foodservice food waste disposer is A typical Foodservice disposer installation incorporates and cUL Listed when installed in conjunction with the following connections (see Figures 1 and/or 9): ® ®...
INSTRUCTIONS PERTAINING TO RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS IMPORTANT SAFETY INSTRUCTIONS NOTICE PERSONAL INJURY/PROPERTY DAMAGE PROPERTY DAMAGE If the electrical installer is not experienced in • Disposers shipped from factory are not wired electrical installation, we recommend seeking for a specific voltage.
3 models. Figure 2. Distance from Table Top to Mounting Flange MOUNTING ADAPTORS There are two adaptor categories for mounting InSinkErator disposers: Standard & Special Mountings. Table 1 displays the approved disposer/mounting adaptor combinations. Adaptor SS-100...
Standard InSinkErator Mountings #5 MOUNTING ASSEMBLY Follow these instructions to install a #5 sink flange to a (1) Stopper standard 3-1/2 to 4 inch sink opening. 1. Unscrew the three backup screws (6) until they are (2) Strainer Flange flush with the upper mounting flange (5) surface. Pry...
Figure 5. #7 or Sink Bowl Mounting Assembly Special InSinkErator Mountings When installing an InSinkErator Foodservice disposer to a non-InSinkErator sink bowl, a special mounting adaptor kit is required. The special mountings are described in the Mounting Adaptor Selection Guide (for more information, call 1-800-845-8345, or go to www.insinkerator.com).
NOTE: A syphon breaker must be installed above the is not experienced in plumbing installation, sink flood plane per local plumbing codes. InSinkErator recommends that competent professional assistance is sought. Damage to the disposer or accessories as a result of...
Standard Motor Connection Wiring Diagrams NOTE: The diagrams below show standard motor connection wiring for a manual switch operation. For alternate controls, please refer to the control panel installation manual. MOTOR LEAD WIRE# MOTOR LEAD WIRE# Figure 10. Incoming 115V Single Phase Line Power Figure 11.
• The magnetic and manual starters supplied by voltage instructions. InSinkErator do not require heaters to complete the circuit. InSinkErator disposers are equipped with • Ensure the disposer motor voltage and phase overload protectors.
Operating Instructions OPERATING THE DISPOSER 1. Make sure there are no foreign objects in the disposer grind chamber. Do not pre-load the disposer with food waste prior to starting. 2. Push the start button on the control switch. The disposer will run and water will flow into the disposer. 3.
Press red reset button to reset overload protector. Never strike reset button with objects. 5. If disposer remains inoperative after following these steps, contact nearest InSinkErator Factory Authorized Service Center (call 1-800-845-8345 to find Service Center nearest you). Disposer motor stops while •...
InSinkErator service representative. InSinkErator® may make improvements and changes in the specification at any time, in its sole discretion, without notice or obligation and further reserves the right to change or discontinue models.