Driver Installation And Advanced Settings; Setting For Receive Side Scaling; Lan Driver And Proset - NEC Express5800/R140a-4 User Manual

D-18 Installing Windows Server 2008

DRIVER INSTALLATION AND ADVANCED SETTINGS

This section describes on how to install and setup various standard drivers mounted on the device.
For the information on installing and setting up the driver that is not described in this section, please
refer to the document attached to the driver.

Setting for Receive Side Scaling

Take the following steps to change setting for the factory-installed network adapters.
1.
Open [Control Panel]. Under [System and Maintenance], click [Open Device Manager] to
start [Device Manager].
2.
Open [Network adapters], and then double-click [Intel(R) PRO/1000 ∼].
3.
Select [Advanced], change [Receive Side Scaling] to "Disabled" and click [OK].
4.
Restart the system.

LAN Driver and PROSet

The LAN driver and PROSet have been installed automatically while your system was being
updated in the previous section.
NOTE:
system from a local console using an administrator account. Remotely
changing the settings by using the operating system's remote desktop
feature is not supported.
Using N8104-125 Adapter after System Update
To use the N8104-125 Adapter after updating your system, you must first uninstall the LAN driver
and PROSet, and then update your system with the N8104-125 Adapter connected.
For a server running a full installation
1.
Remove a team of network adapters.
NOTE:
addresses) of the standard and optional adapters teamed for network
redundancy.
Configure the settings after reinstalling the LAN driver and PROSet.
To remove the team, see "Adapter Fault Tolerance (AFT)/Adaptive
Load Balancing (ALB)".
2.
In Control Panel, click Uninstall Program.
To change the LAN driver and PROSet settings, log on to the
Before you remove, note down the current settings (e.g. IP