Troubleshooting Pppoe Or Pppoa - NETGEAR DG834G Reference Manual

Reference Manual for the ADSL Modem Wireless Router DG834G
• If you have selected a login program, you may have incorrectly set the Service Name, User
Name and Password. See
• Your ISP may check for your computer's host name.
Assign the computer Host Name of your ISP account to the modem router in the browser-
based Setup Wizard.
• Your ISP only allows one Ethernet MAC address to connect to Internet, and may check for
your computer's MAC address. In this case:
Inform your ISP that you have bought a new network device, and ask them to use the router's
MAC address.
OR
Configure your router to spoof your computer's MAC address. This can be done in the Basic
Settings menu. Refer to the ADSL Modem Wirelesss Router Setup Manual (see
page 3-1).

Troubleshooting PPPoE or PPPoA

The PPPoA or PPPoA connection can be debugged as follows:
1. Access the Main Menu of the router at http://192.168.0.1.
2. Under the Maintenance heading, select the Router Status link.
3. Click the Connection Status button.
4. If all of the steps indicate "OK" then your PPPoE or PPPoA connection is up and working.
5. If any of the steps indicates "Failed", you can attempt to reconnect by clicking Connect. The
modem router will continue to attempt to connect indefinitely.
If you cannot connect after several minutes, you may be using an incorrect Service Name, User
Name or Password. There also may be a provisioning problem with your ISP.
Note: Unless you connect manually, the modem router will not authenticate using
PPPoE or PPPoA until data is transmitted to the network.
9-6
"Troubleshooting PPPoE or
v1.3, March 2007
PPPoA", below.
Table 3-2 on
Troubleshooting