Vpn Tunnel Configuration - NETGEAR DG834G Reference Manual

Reference Manual for the ADSL Modem Wireless Router DG834G

VPN Tunnel Configuration

There are two tunnel configurations and three ways to configure them:
• Use the VPN Wizard to configure a VPN tunnel (recommended for most situations):
— See "How to Set Up a Client-to-Gateway VPN Configuration" on page
— See "How to Set Up a Gateway-to-Gateway VPN Configuration" on page
• See "Using Auto Policy to Configure VPN Tunnels" on page 8-38
its VPNC defaults (see
want to automate the Internet Key Exchange (IKE) setup.
• See "Using Manual Policy to Configure VPN Tunnels" on page 8-48
and its VPNC defaults (see
you must specify each phase of the connection. You manually enter all the authentication and
key parameters. You have more control over the process, however the process is more
complex and there are more opportunities for errors or configuration mismatches between
your DG834G v3 and the corresponding VPN endpoint gateway or client workstation.
Note: NETGEAR publishes additional interoperability scenarios with various
gateway and client software products. Look on the NETGEAR web site at
www.netgear.com
8-6
Table 8-2) are not appropriate for your special circumstances, but you
Table 8-2) are not appropriate for your special circumstances and
for these interoperability scenarios.
v1.3, March 2007
8-7.
8-21.
when the VPN Wizard and
when the VPN Wizard
Virtual Private Networking