Mu Dissasociation Codes - Motorola WS5100 Series Troubleshooting Manual

2-46 WS 5100 Series Switch Troubleshooting Guide
Number
647. DAEMON-5-NOTICE:
WIOS_SECURITYMGR
648. DAEMON-6-INFO:
WIOS_SECURITYMGR
649. DAEMON-6-INFO:
WIOS_SECURITYMGR
650. DAEMON-6-INFO:
WIOS_SECURITYMGR
651. DAEMON-6-INFO:
WIOS_SECURITYMGR
652. DAEMON-6-INFO:
WIOS_SECURITYMGR
654. DAEMON-6-INFO:
WIOS_SECURITYMGR
655. DAEMON-2-CRIT:
WIOS_SECURITYMGR
656. DAEMON-2-CRIT:
WIOS_SECURITYMGR
657. DAEMON-2-CRIT:
WIOS_SECURITYMGR
658. DAEMON-4-WARNING:
WIOS_SECURITYMGR

2.2 MU Dissasociation Codes

The following table provides reason codes for 802.11 mobile unit disassociation.
Mnemonic Severity
5
6
6
6
6
6
6
2
2
2
4
Syslog Message
Remote L2TP Layer 2 error generated as a result of
implementation (Vendor unknown vendor name not matching
Name `%.*s') is ""not RFC 2661 standard.
standard-compliant: " "the
Mandatory bit (%s) of the
AVP `%s' (%d) " "does not
match RFC 2661
"""%s: Can't copy NetBIOS NOT SUPPORTED.
scope ID; reason: ""
%s: Can't serve connection; Existing space does not permit
reason: no space. updates to configuration. Space must
be freed to make requested update.
Lifetime: %u kilobytes, %u Lifetime of the IP Sec SA in both
seconds kilobytes and seconds.
Lifetime: %u seconds Lifetime of the IP Sec SA in seconds
Lifetime: %u kilobytes Lifrtime of the IP Sec SA in kilobytes
"The PPP implementation of PPP support mis-match between
the remote L2TP client "" switch and client. Ensure the selected
""(Vendor Name `%.*s') switch authentication method is
does not handle PPP "" supported on client and try again.
""authentication method
negotiation correctly: ""
disabling EAP
"service %s: insufficient Existing memory space does not
memory available, "" permit updates to configuration.
""unable to apply new Memory space must be freed to make
configuration requested update.
"service %s: internal error, This error message occurs when
could not "" ""unmarshal security manager encounters a failure
configuration! while unmarshalling a configuration
for application gateways.
"registering HTTP APPGW HTTP gateway failure. Re-establish
failed: %s HTTP connection.
"""No IKE logging enabled. Login not enabled for IKE negotiation.
The system has not ""
""been compiled with `--
enable-debug'.
Meaning / Cause