Shutting Down The Switch Using The Halt Command - Motorola WS5100 Series Troubleshooting Manual

A manual power cycle will be required to re-start the switch.
Do you want to proceed (yes/no) : yes
System shut down might take a few mins....
Shutting down the switch...
Shutting down dhcp daemon.. done
Shutting down apache server in the OPEN mode...done.
Shutting down cell controller........ done
Shutting down snmpd agent...done.
Shutting down Postgres....done.
INIT: Sending processes the TERM signal
Shutting down PacketSwitch interface
Shutting down dhcp daemon.. done
Shutting down apache server in the OPEN mode...done.
Cell controller not running.
i2c-core: Device or resource busy
Shutting down Postgres....done.
Stopping periodic command scheduler: cron.
Stopping internet superserver: inetd.
Saving random seed... done.
Stopping deferred execution scheduler: atd.
Stopping kernel log daemon: klogd.
Stopping system log daemon: syslogd.
flushing ide devices: hda
System halted.
As directed, wait 10 seconds and turn off the device by toggling the power switch.

1.1.8.2 Shutting Down the Switch Using the Halt Command

To shut down the WS 5100 from the CLI, issue a halt command, as the halt command is now used to shut
down the switch with the release of the 3.x version WS5100 baseline:
WS5100#halt
Wireless switch will be halted, do you want to continue? (y/n):y
The system is going down NOW !!
% Connection is closed by administrator!
WIOS_SECURITYMGR[395]: DNSALG: Shutting down.
WIOS_SECURITYMGR[395]: FTPALG: Shutting down.
The system is halted.
NOTE: The WS5100 will power off after issuing a halt command through a software
toggle of the power supply. Be sure to flip the power switch to the Off position. If the
power cord is removed and reinstalled, or power is lost and restored, the switch will
power back on.
.....
1-5
Overview