Step 1 Connection - Panasonic Diga DMR-EZ49V Operating Instructions Manual

1
STEP Connection
Using a 21-pin Scart cable
≥You can use a variety of Q Link functions by connecting the unit to a Q Link compatible television (
≥You can enjoy high-quality viewing by connecting the unit to an RGB compatible television (
Required setting
"AV1 Output" in the Setup menu (
≥Before connection, turn off all equipment and read the appropriate operating instructions.
≥Select the connection pattern that matches your environment from pattern A–B. Confirm connections not listed below with your
dealer.
≥Refer to "Additional connections" (
When the unit is not to be used for a long time
To save power, unplug it from the household mains socket. This unit consumes a small amount of power, even when it is turned off
[approx. 0.5 W ("Power Save in Standby" is activated and "RF OUT ( Aerial Signal )" is set to "Off".)]
A Connecting a television
To household mains socket
(AC 220 to 240 V, 50 Hz)
AC mains lead
(included)
Connect only after all other
connections are complete.
4
AC IN
B Connecting a television and digital satellite receiver
To household mains socket
(AC 220 to 240 V, 50 Hz)
AC mains lead
(included)
Connect only after all other
connections are complete.
5
AC IN
Connect the unit directly to the television
If you connect the unit through an AV selector or
video cassette recorder to the television, video
signal will be affected by copyright protection
systems and the picture may not be shown
correctly.
≥When connecting to a television with a built-in VCR
Connect to the input terminals on the television side if there are
both television and VCR input terminals.
VQT2J52
8
66)
70) for connection using other terminals and connection with other equipment.
Connecting a terminal other
than the 21-pin Scart
terminal (
Cooling fan
OPTICAL
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
Connecting a terminal
other than the 21-pin Scart
terminal (
Cooling fan
OPTICAL
DIGITAL AUDIO OUT
(PCM/BITSTREAM)
DO NOT
Television
VCR
This unit
Television's rear panel
9, 71)
Fully wired 21-pin
Scart cable
R- AUDIO-L VIDEO
AV2 (DECODER/EXT) AV2 (EXT)
OUT
Television's rear panel
9, 71)
Fully wired 21-pin
Scart cable
R- AUDIO-L VIDEO
AV2 (EXT)
OUT
4
21-pin Scart cable
AV
Required setting
"AV2 Input" setting in the Setup menu (
42).
86).
To the aerial
AV VHF/UHF
RF IN
RF coaxial
cable
(included)
3 2
RF RF
IN IN
RF RF
OUT OUT
Aerial cable
AV1 (TV)
This unit's rear panel
To the aerial
AV VHF/UHF
RF IN
RF coaxial
cable
(included)
2
3
RF RF
IN IN
RF RF
OUT OUT
Aerial cable
AV1 (TV)
This unit's rear panel
Digital satellite receiver's rear panel
66)
1
1