Panasonic Diga DMR-EZ49V Operating Instructions Manual page 82

Troubleshooting guide
VHS
On-screen display indicators do not appear.
Select a setting other than "Off" in "On-Screen Messages" in the
Setup Menu. ( 65)
– Press [STATUS
– The on-screen indicator for video cassette playback will not
be displayed when this unit is connected to the TV with the
DVD priority out terminals.
The grey background appears during playback.
You are playing a blank or poor quality portion of the tape.
You can damage the unit if you play dirty or damaged tapes and
this can cause the grey background to appear.
Cannot hear the desired audio type.
Press [AUDIO] to select the audio. (
There is noise when playing a video tape.
Adjust the tracking. (
The tape is old or damaged.
The playback screen flickers.
The video head is dirty. (
The tape is old or damaged.
Check the "SQPB" setting. (
"1" flashes when I try to start recording.
Cannot record.
A video cassette is not inserted. Insert a video cassette with an
accidental erasure prevention tab. (
The accidental erasure prevention tab has been removed.
Cover the hole with adhesive tape. (
USB
The contents of the USB memory cannot be read.
Remove the USB memory from the USB port and then insert
again. If this does not solve the problem, turn off and turn on the
unit again.
Check that the USB memory is inserted correctly. (
The format of the USB memory or of its contents is not
compatible with the unit. (The contents on the USB memory
may be damaged.) (
The USB memory contains a folder structure and/or file
extensions that are not compatible with this unit. (
Turn off and then turn on the unit again.
USB memories connected using a USB extension cable or a
USB hub may not be recognized by this unit.
Some USB memories cannot be used with this unit. (
If inserted during playback, recording or copying etc., the USB
memory may not be recognized by this unit.
VQT2J52
82
] to show the on-screen display indicators.
37)
37)
5)
67)
5)
5)
13, 14)
14)
TV Guide
The TV Guide System does not receive any data.
Check whether TV Guide system setup was performed in full.
Check whether the clock is properly set. (
If signal quality is bad (ghost images or limited reception), the
TV Guide system may not be able to receive any data.
In the area where GUIDE Plus+ system is available, check
whether correct post code is entered. (
"No Data" is displayed for some or all stations.
Some stations are not supported by the TV Guide system.
Analogue broadcasts are not supported by the TV Guide
system.
Programme the Timer recording manually or via S
([For]Germany[and]Austria[). (
The TV Guide information is not displayed
properly.
There was a programme change.
Check the current programme, e.g. on the Web site for the TV
Guide system provider or station provider.
Programme information about analogue broadcasts is not
displayed.
The TV Guide data transfer was interrupted.
The TV Guide system shows the data that was received up to
the interruption.
The programme information may be incomplete.
The TV Guide data is not updated.
The unit must be in standby mode in order to update the data. If
the unit is in EXT LINK mode (EXT-L lights up in the display),
then the data update may also not work.
Make sure that the time is set correctly.
Make sure that "TV Guide Download in Standby" is set to "On".
( 68)
15)
13)
67)
68)
V
HOW IEW
30)